Industrial
Cat® C3.6 Diesel Engine
-
Maximum Power134 hp
-
Maximum Torque406 lb-ft @ 1500 rpm
-
Rated Speed2000-2400 rpm
-
Minimum Power74 hp
Power Rating
- Maximum Power
- 134 hp
- Maximum Torque
- 406 lb-ft @ 1500 rpm
- Rated Speed
- 2000-2400 rpm
- Minimum Power
- 74 hp
Emission Standards
- Emissions
- U.S. EPA & CARB Tier 4 Final, EU Stage V
General
- Engine Configuration
- In-Line 4, 4-Stroke-Cycle Diesel
- Engine Configuration
- In-Line 4
- Bore
- 3.9 in
- Stroke
- 4.7 in
- Bore
- 98 mm (3.9 in)
- Displacement
- 220 in³
- Compression Ratio
- 17.0:1
- Stroke
- 120 mm (4.7 in)
- Aspiration
- Turbocharged-Aftercooled (TA)
- Combustion System
- Direct Injection
- Displacement
- 3.6 L (220 in³)
- Rotation from Flywheel End
- Counterclockwise
- Aftertreatment
- DOC+DPF or DOC+DPF+SCR
- Cooling System Capacity
- 4 L (1.06 qt)
- Cooling System
- 4 L (1.06 qt)
Engine Dimensions - Approximate
- Length
- 26.3 in
- Width
- 22.2 in
- Height
- 31 in
- Weight
- 840 lb
- Dry Weight
- 381 kg (840 lbs)
- Height
- 787 mm (30.98 in)
- Length
- 667 mm (26.3 in)
- Width
- 564 mm (22.2 in)
Aftertreatment Dimensions (Approximate. Final dimensions dependent on selected options)
- DOC Length
- TBA
- DOC Weight
- TBA
- DOC Diameter
- TBA
- SCR Weight
- TBA
- SCR Diameter
- TBA
Aftertreatment Dimensions - Approximate
- SCR Length
- TBA
- SCR Weight
- TBA
- DOC Diameter
- TBA
- DOC Length
- TBA
- DOC Weight
- TBA
- SCR Diameter
- TBA
Engine Dimensions (Approximate. Final dimensions dependent on selected options)
- Length
- 667 mm (26.3 in)
- Width
- 569 mm (22.4 in)
- Height
- 776 mm (30.6 in)
-
Control System
- Starter motor (12V or 24V)
- Alternator (12V or 24V)
- Electronic Control Unit (chassis mounted)
- Engine control sensors and robust wiring harness
- Data interface via CANbus J1939
-
Flywheels and Flywheel Housing
- Flywheel housings – SAE 3 or SAE 4
- Choice of flywheel to match industry common hydraulic pumps and transmissions
- Side PTO with SAE A or SAE B interface
-
Fuel System
- Fuel filter – preconnected but chassis mounted
- With water sensor
-
Lube System
- Lubricating oil filters
- High incline oil pan – 35° continuous in all directions
-
General
- Cold start capability to -20° C (-4° F) with standard equipment
- Paint: Caterpillar yellow, with optional colors available at request
-
U.S. EPA Tier 4 Final, EU Stage V Aftertreatment/ Clean Emissions Control Equipment
- Diesel Oxidation Catalyst (DOC)
- Selective Catalytic Reduction (SCR)
- SCR Auxiliaries