Marine Generator Sets
Cat C280-6 Marine Generator Set
-
Minimum Rating1760 ekW (2200 kVA)
-
Minimum Rating1760 ekW (2200 kVA)
-
Power Range1720 - 1820 ekW
-
Maximum Rating1820 ekW (2275 kVA)
Generator Set Specifications
- Minimum Rating
- 1760 ekW (2200 kVA)
- Minimum Rating
- 1760 ekW (2200 kVA)
- Maximum Rating
- 1820 ekW (2275 kVA)
- Maximum Rating
- 1820 ekW (2275 kVA)
- Frequency
- 50 / 60 Hz
- Frequency
- 50 Hz or 60 Hz
- Emissions
- U.S. EPA Tier 2, IMO II
- Speed
- 1000 rpm (50 hz) or 900 rpm (60 hz)
- Speed
- 1000 rpm (50 hz) or 900 rpm (60 hz)
Power Rating
- Power Range
- 1720 - 1820 ekW
Engine Specifications
- Engine Model
- In-line 6, 4-Stroke-Cycle Diesel
- Aspiration
- Turbocharged-Aftercooled
- Aspiration
- Turbocharged - Aftercooled
- Bore
- 11.0 in
- Bore
- 11 in
- Stroke
- 11.8 in
- Stroke
- 11.8 in
- Displacement
- 6773.0 in3
- Displacement
- 6773 in³
- Governor Type
- Electronic
- Governor Type
- Electronic
- Fuel System
- EUI
- Compression Ratio 50 Hz
- 13.1
- Compression Ratio 60 Hz
- 13:1
- Engine Model
- In-line 6, 4-Stroke-Cycle Diesel
Generator Set Configurations
- Emissions
- EPA Tier 2, IMO II
Generator Set Dimensions
- Length
- 280.3 in
- Length
- 280.3 in
- Width
- 77.2 in
- Width
- 77.2 in
- Height
- 154.9 in
- Height
- 154.9 in
- Weight
- 18000.0 lb
- Weight
- 18000 lb
-
Air Inlet System
- Aftercooler — fresh water, corrosion resistant coated (air side); air inlet shutoff; breather — crankcase, top-mounted; turbocharger — engine oil lubricated
-
Control System
- Single Caterpillar® A3 electronic control unit (ECU) with electronic unit injector fuel system, rigid wiring harness (10 amp, 24 volt power required to drive ECUs)
-
Cooling System
- Engine coolant water drains
-
Exhaust System
- Dry, gas tight, exhaust manifold
-
Fuel System
- Distillate fuel (requires viscosity ranging from 1.4 cSt to 20 cSt at 38° C), fuel transfer pump (mounted on left-hand side), duplex fuel filters, electronically controlled unit injectors
-
Lube Oil System
- Centrifugal oil filters with single shutoff, service side engine mounted on cylinder block inspection covers includes installed oil lines and single shutoff valve, filters centrifuge bypass oil from the main lubricating oil pump, can be serviced with the engine running, oil filler and dipstick valve, oil pressure regulating valves, crankcase explosion relief valves
-
General
- Caterpillar yellow paint; gear-driven pumps: fuel, oil, jacket water, aftercooler/oil cooler water; service literature